How do you clean a residential grease trap?
How do you clean a residential grease trap?
How to Clean a Grease Trap
- Lift up the main lid and pump out the grease trap.
- Scrape down all walls and baffles to remove accumulated grease and dirty water.
- Rinse out the tank with a garden hose.
- Pump out the rinse out residue.
- Inspect the tank and advise of any repairs or maintenance needed.
How do you unblock a grease trap?
How to Clean Your Grease Trap
- Remove the lid from the grease trap.
- Stick a ruler into the grease trap and note how many inches of grease are in the trap.
- Remove the water from your grease trap, either with a bucket or a small pump.
- Start scooping out the grease from your trap.
How do you clean an outside grease trap?
For a thorough cleaning, utilize the shop vacuum to suck out any lingering FOGs from the grease trap. Next, refresh the grease trap and free the tank from obnoxious odors with a little elbow grease, a steel pot scrubber, dish soap and tepid water. Thoroughly scrub down the grease trap’s baffles, sides and lid.
How much does it cost to replace a grease trap?
A: The average install for a small grease trap (0-100 gallons) is between $250 and $1500. The average cost for the installation of a new grease trap (750-1500) is between $4,000 and $8,500. Grease recovery devices cost between $3,500 and $6,000.
How do you clean a commercial grease trap?
Scrape down the lid and the sides of the trap with your bucket. Remove any large pieces of fat or oils that are attached to the trap. To achieve an even cleaner trap, you can use a wet/dry vacuum to suck out any smaller bits of waste. Clean the lids, trap sides, and parts with soap and room-temperature water.
How do you clean a restaurant grease trap?
With most of the grease removed, it’s time to give the trap a shine. Use soap, warm water, and a steel pot scrubber to clean the lids, sides, baffles, and other parts of the trap. Doing this will also eliminate bad odor from the trap. Flush the trap with clean water to remove soap and debris.
What is a commercial grease trap?
Commercial Grease Traps & Interceptors. A. A grease trap works by slowing down the flow of warm/hot greasy water and allowing it to cool. As the water cools, the grease and oil separate and float to the top of the grease trap. The cooler water (less grease) continues to flow down the pipe to the sewer.
What is grease trap service?
A grease trap (also known as grease interceptor, grease recovery device and grease converter) is a plumbing device (a type of trap) designed to intercept most greases and solids before they enter a wastewater disposal system.
https://www.youtube.com/channel/UCtQ5zomKBITGp9O_JsdyORQ