How do I put a USB charging port on a lamp?

Using a cutting tool like a Dremel, cut the hole in the lamp base. Connect the charging side of the USB adapter to the lamp. Tuck in the charger body and replace the felt bottom. Plug in the lamp; plug in the electronics.

How does a USB lamp work?

USB LED lights work with any operating system and any USB port that delivers 5-volts of power. If a light is left plugged into a USB port and the machine is turned off, the light will also turn off. Lamps are extremely lightweight and can be easily stowed in a computer case.

Can we use table lamp while charging?

There is indicator of battery charging but there is no indicator available which shows full battery charge or level of battery charge. -Eye Protection Study Table Lamps. Please do not use while charging , please do not turn on while charging.

Can I use rechargeable light while charging?

Yes, but it’s negligible for all modern chargers.

Which USB port is faster for charging?

A USB-C connection can charge devices up to 20 times faster than basic USB. USB-C ports support USB Power Delivery, a fast-charging standard that can deliver 100 watts of power to compatible devices.

What type of table lamp do I need to house a charger?

Depending on the table lamp you are going to use to house your charger f, your design will vary and thus the parts and equipment required will to. Below is a generic list based on what we used, it is not complete but should give you a pretty good idea. Low voltage table lamp (anything between 7-24v will work, we used a 12v one from B&Q).

What power supply do I need to run a table lamp?

Low voltage table lamp (anything between 7-24v will work, we used a 12v one from B&Q). 5V USB DC 7V-24V to 5V 3A Step Down Buck Converter Module. Snap-in Miniature Round Rocker Switch Black (to turn the light on and off).

What tools do I need to charge my lamp?

(Optional) Larger AC adapter, without this you will not be able to charge and use your lamp at the same time, one capable of supplying 650mA and 3000mA is best with appropriate connector for your lamp. Basic hand tools e.g. screwdrivers, wire cutters, craft knife, spanner, a hammer, pliers etc.

How to wire a light switch to a circuit board?

We opted to solder our wires to the board but you could use the screw terminals provided. You will then need to take a wire from positive of the socket to switch and from the positive of the lamp to switch in our case the white wire. Then take connect the ground from the lamp to the ground of the socket.