How do I remove a stuck CV joint?

6:49Suggested clip 60 secondsREMOVE STUCK CV AXELS EASY – YouTubeYouTubeStart of suggested clipEnd of suggested clip

How do you separate a CV joint?

6:33Suggested clip 118 secondsHow to separate a CV joint on a drive shaft axle Ford Mondeo …YouTubeStart of suggested clipEnd of suggested clip

What size is the axle nut on a 2005 Chevy Equinox?

34mm

What size is the axle nut on a 2006 Chevy Equinox?

30mm

What size is the axle nut on a 2005 Chevy Silverado?

Dorman AutoGrade M24-2.0 Thread Spindle Nut.

How do you change the front hub on a 2006 Chevy Silverado?

10:02Suggested clip · 99 secondsHow to Replace Wheel Bearing & Hub 99-06 Chevy Silverado 1500 …YouTubeStart of suggested clipEnd of suggested clip

How do you change a front wheel bearing on a 2005 Chevy Silverado?

8:19Suggested clip · 77 secondsHow to Replace the Front Wheel Bearings on a 2000-06 Chevy …YouTubeStart of suggested clipEnd of suggested clip

How long does it take to replace a wheel bearing?

Some rear/4WD vehicles have the bearing and hub permanently assembled and bolted to the spindle. While making for a more expensive replacement part, removal and replacement only takes 20-30 minutes. Rear axle bearings on rear wheel drive/4 wheel drive are a big job that will run several hours.

How long do wheel bearings last?

Wheel bearings have an average lifespan of 136,000 to 160,000 km (approximately 85,000 to 100,000 miles). This is only a rule of thumb though, the actual lifespan of a wheel bearing depends on the quality of the wheel bearing and the operating conditions.

How long can you drive on bad wheel bearings?

The heat would crash the wheel completely. To avoid this situation, it is recommended to drive at the slower speed so that your wheel stays in action a few more hours. SO, while thinking how long can you drive on a bad bearing? You should not go more than 1000 miles as it might result in some bigger issue.

What tools are needed to change a wheel bearing?

What tools do I need to replace a wheel bearing? Needle-nose pliers, a ratchet wrench with various sized sockets, flat-head screwdriver, jack and a star wrench for loosening nuts on the wheel.

Is changing wheel bearings hard?

Replacing a wheel bearing that comes as an assembly with the hub and bolts to the spindle or steering knuckle is not very difficult if you have proper skills, tools and the manual. Of course, the large axle nut is very tight and can be difficult to remove.