How do I reset my HP LaserJet 1320?

The correct procedure for a cold reset is to turn the printer off….

1. Turn the printer off.
2. Press and hold down the GO button.
3. Turn the printer on, and continue to hold the GO button for at least 20 seconds. During. this process, the GO button, Attention, and Ready LEDs each turn on.
4. Release the GO button.

How do I print a test page on HP LaserJet 1320?

When the printer is in the Ready state, press the GO button for about five seconds, until the Attention light turns on, and then release the button. Select Start, Programs or All Programs, Hewlett-Packard, HP LaserJet 1160 or HP LaserJet 1320, and choose HP Toolbox. Click the Status tab to print the configuration page.

What toner do I need for HP LaserJet 1320?

HP 49A
Your HP LaserJet 1320 printer is designed to work with original HP 49A and HP 49X toner cartridges. Only original HP Q5949A, Q5949X, Q5949XD toner cartridges can provide the results your printer was engineered to deliver.

Is HP LaserJet 1320 Wireless?

Note The printer cannot be connected to a wired and wireless network at the same time. The HP LaserJet 1320nw printer has an internal networking component that provides wireless connectivity. To view the status of the wireless communications, the printer contains a Wireless light.

How do I clean the printhead on my HP LaserJet 1320?

Select “Printing Preferences” and then “Printer Services” or “Printer Utility.” Access “Printer Alignment, “Nozzle Check” or “Print Head Cleaning” utilities and follow the instructions that will appear on your screen to complete each process.

How do I do a clean cycle on my HP printer?

Click Settings ( ), and then click Printer Toolbox. The printer Toolbox opens. Click the Device Services tab, and then click Clean Printheads. Click Clean to begin the cleaning process, and then follow the on-screen instructions to complete the process.

How do I print double sided on HP LaserJet 1320?

On the PRINT dialog box, make sure the HP 1320 printer is selected, and click the “Properties” button. 3. In the PROPERTIES dialog box, click on the “Finishing” tab, then uncheck the box next to “Print on both sides” and click OK to save your changes.