Why is my Delta tub faucet leaking?

Delta tub faucets contain rubber seats that look similar to washers as well as metal springs to help regulate the flow of hot and cold water through the faucet. When you start to see water leaking out of the spout, you will need to replace the worn seats and springs to correct the problem.

How do you take apart a Delta tub faucet?

How to Remove a Delta Tub Spout

1. Step 1: Protect the Spout From Scratches.
2. Step 2: Loosen and Unscrew the Spout.
3. Step 3: Remove Old Caulk and Plumber’s Tape.
4. Step 4: Reinstall the Spout.
5. Step 5: Add New Caulk.
6. Step 1: Remove the Set Screw.
7. Step 2: Slide Spout Away From Wall.
8. Step 3: Remove Old Caulk and Plumber’s Tape.

How do you replace an O-ring in a bathtub faucet?

Replacing the O-ring is simple. Just pull the valve stem out and remove the old O-ring. Put a small amount of petroleum jelly or silicone on the new O-ring and slide it on the stem. Before you reattach the escutcheon, you can apply a little bathtub caulk.

Why is my new Delta shower faucet leaking?

A dripping/leaking Delta shower faucet is almost always caused by a faulty cartridge. This is usually due to worn out cartridge seats and springs, mineral deposits/debris or worn out O-rings. Replacing the entire cartridge or the seats and springs will fix the problem.

Where is the O-ring on a bathtub faucet?

If you have a single handle faucet, you may have a worn-out O-ring. The O-ring fits around the valve stem and when it wears out, the faucet springs a leak. Replacing the O-ring is simple. Just pull the valve stem out and remove the old O-ring.

How to repair a leaky Delta Faucet.?

1) Look to see whether the spout is dripping—this is the most common cause of a leak. 2) Shut off the hot and cold water supply valves, which are usually silver knobs under the sink. Turn on the faucet to drain any water in the lines. 3) After removing the screw cover on the faucet handle, use a screwdriver to lift off the actual handle. 4) Once you lift off the handle, you’ll see a cap and adjusting ring. If water is leaking, tighten the ring with needle-nose pliers. 5) Remove the adjusting ring and unscrew the dome-shaped cap. 6) Remove the round metal stem and pull out the ball and cam and packing. 7) Look down into the bottom of the valve and you’ll see the seats and springs. 8) To insert a new set of seats and springs, thread one set onto the Allen wrench through the flat side of the seat, then through the skinny end

How do you repair a Delta single handle faucet?

Turn off the water to the faucet, then open the faucet to relieve the water pressure. Loosen the screw holding the faucet handle, and remove the handle. Take off the escutcheon plate around the faucet by removing the screws holding it in place. Loosen the bonnet nut holding the faucet stem in the housing.

How do you repair a bathtub faucet?

Insert the bonnet and tighten it with your bath socket wrench or vice grip. Replace the collar, faucet trim, faucet handle, faucet screw and faucet insert. Repeat on the other side to replace parts in the opposite handle. Turn the water back on and test your repair job.

How to stop a dripping bathtub faucet?

– If your tub faucet is leaking, the first step is to locate the water supply valve and turn it off. – If you cannot find the main valve, turn off your home’s main water supply lines instead. – Turn the handle (or handles) to the on position and let all remaining water from the pipes drain into the bathtub.